I wasn't going to brick it up - I was going to seal around the flue once it went into the chimney to stop draft coming down - and then finish off the old fireplace / rectangle with plaster board, then skim and plaster it leaving it there.
Space would be left where old fireplace was and finished off the same as the chimney breast and all you could see was the flue going in and up inside the fireplace - hope I'm explaining this right. That is why I am asking about supporting the flue ? and the other option MD O'Shea said was steel and not as heavy as cast iron
We use cookies and similar technologies for the following purposes:
Do you accept cookies and these technologies?
We use cookies and similar technologies for the following purposes:
Do you accept cookies and these technologies?