Jackhammer
Registered User
- Messages
- 1
Hi all. I'm a nuub so please bare with me!
So I have a Beko DIN15R10 and no hot water running through the machine. I got myself a multimeter, so I removed the Flow Through Heater and the Thermistor Temperature Sensor Ntc. Neither of which seem to be the problem.
For the Flow through Heater, i was getting around 30ohm. For the NTC, i heated it up and the readout dropped to around 7 and once let to cool off, went back up to 50. Thats if I was actually using the multimeter correctly, never used one before. I'm not much into my electrics so was getting a friend to help me out through texts! Could these still be the issue and I just didn't test them properly?
So whats next to check the pcb?
Thanks in advance everyone! Not sure where to go now.
So I have a Beko DIN15R10 and no hot water running through the machine. I got myself a multimeter, so I removed the Flow Through Heater and the Thermistor Temperature Sensor Ntc. Neither of which seem to be the problem.
For the Flow through Heater, i was getting around 30ohm. For the NTC, i heated it up and the readout dropped to around 7 and once let to cool off, went back up to 50. Thats if I was actually using the multimeter correctly, never used one before. I'm not much into my electrics so was getting a friend to help me out through texts! Could these still be the issue and I just didn't test them properly?
So whats next to check the pcb?
Thanks in advance everyone! Not sure where to go now.