I have several rooms to paint. Painting kitchen at present. My problem is although I am a neat painter, prep the walls properly and take my time at the job. I do not seem to be able to get a good clean finish when 'cutting in' at wall/ceiling. Any recommendations as to what cutting in brush is best? Is there a tip for perhaps thinning the paint etc.? What do you recommend as to the order of work should you do the cutting in first and the rollering neatly to meet up? I have to DIY as there are budget constraints. I would really want to get a nice clean finish. Thanks.
a good, quality 3-inch brush, a steady hand, a bit of patience and plenty of practice.
I'll invest in best quality I can afford in a 3" brush. I must admit I would not have considered using a wider paint brush to do 'cutting in' but will indeed give it a try.
I have thought about borders or coving but I have been informed they are not on trend at present!
I would say don't go to B&Q or Woodies, go into your local paint specialist, he/she'll be able to advise the best buy for your task
u dont use masking tape as that will take the paint off the wall. u need a steady hand!
best lines I've ever got!!
I've never hand much time for masking tape when it comes to cutting in; a proper, good quality brush, properly loaded with paint and a good technique (practice and a steady hand) will give the best results. If using water based paints on walls and ceilings it's easy to correct a mistake with a damp cloth or sponge and redo it. When buying brushes for use with emulsion go for artificial bristle and a brush with a stainless steel ferrule. I find "Signature Pro" to be good value and good quality. If corners are undercoat or uneven run a bit of acrylic caulk along the joint, makes it easier to cut in. I was told the correct order for painting a room (and less cutting in as a result) is: prime and undercoat woodwork, allowing undercoat to "flash over" slightly onto walls. Paint ceiling and walls in emulsion, apply finish top coat to woodwork, taking time to cut in neatly. Never try and paint around door handles and other ironmongery etc- if it can be easily removed do so and refit when painting is complete and cured.
I'm going to invest in a good artifical cutting in brush, perhaps 'signature pro' as recommended if I can find it. Don't mind paying a bit more as I said because I always wash and air dry brushes on window sill overnight so they are good as new for next time. I think alot of money can be wasted by getting cheapo brushes and throwing them away at the end of the job. When you are faced with another job the accessories can cost as much as the paint.... I also note that I was definitely getting the order of the job wrong and making awkward work for myself. I have all the rooms to work my way through so will get plenty of practice.Thanks for all tips and replies, much appreciated.
We use cookies and similar technologies for the following purposes:
Do you accept cookies and these technologies?
We use cookies and similar technologies for the following purposes:
Do you accept cookies and these technologies?