Integrated freezer

[Beckster]

Hi everyone!
We have an integrated freezer in the kitchen. Recently the door of the freezer is not shutting properly, resultly in wasted electricity and time spent defrosting.
It appears to be due to the fact that the wooden door attached to the freezer is closer to the edge of the frame that the freezer sits in, at the bottom, than at the top. So the freezer is not shutting properly at the top.
Any suggestions on how to fix this....
How do I take the wooden door off the freezer (can't see an obvious place to unscrew it)???
Also, should I be worried about the kitchen press doors warping???
Any advice appreciated.
Beckster

 

[Percival]

If it was ok before then the most probable thing is the freezer itself has moved back into its recess if it is far enough out then the fact that the cover door is not fully straight should not matter.

In relation to taking the door off there are two possibilities.

1 the door is held on by side panels or 2 the door is hanging on brackets which are bolted to the unit and should lift up and off with a little tapping from underneath.

 

[Beckster]

Thanks Percival,
I realised on further inspection that moving the freezer forward under the counter was a hell of a lot easier than taking the door off, so I did that!
Problem solved...