Hi all,
Looking for advice on removing skirting boards which ideally I would like to reuse. Reason is I want to install a solid oak floor and would like to lay under the skirting boards. Have considered just using beading around the edge but think would look better under the skirting boards.
Have two ideas
1. Use screwdriver to start removing board and then gat claw bar behind and lever against wall and screwdriver
2. Use screwdriver and wooden wedges. Hammer down the wedges then to remove boards
Any advice , comments on the above
Thanks
Looking for advice on removing skirting boards which ideally I would like to reuse. Reason is I want to install a solid oak floor and would like to lay under the skirting boards. Have considered just using beading around the edge but think would look better under the skirting boards.
Have two ideas
1. Use screwdriver to start removing board and then gat claw bar behind and lever against wall and screwdriver
2. Use screwdriver and wooden wedges. Hammer down the wedges then to remove boards
Any advice , comments on the above
Thanks