Folks,
Have a terrible feeling that I may have a leak in one of my UFH loops. When multiple loops are "open", the flow rate in one is significantly higher than the others and I have noticed some very obvious pigmentation in a number of oak floorboards in a walk in robe. Is there any easy way to disconnect this one loop from the flow/return manifolds & test it under pressure to rule in/out a leak? Hope I'm wrong about the flow rates but feeling nervous! Thanks in advance.
Have a terrible feeling that I may have a leak in one of my UFH loops. When multiple loops are "open", the flow rate in one is significantly higher than the others and I have noticed some very obvious pigmentation in a number of oak floorboards in a walk in robe. Is there any easy way to disconnect this one loop from the flow/return manifolds & test it under pressure to rule in/out a leak? Hope I'm wrong about the flow rates but feeling nervous! Thanks in advance.