paddyodoors
Registered User
- Messages
- 293
Hi
I am a novice radiator bleeder, and have a problem - we have a rad where the top is cold and bottom warm, so suspect just needs to be bled to drain out the trapped air - however there is not a valve on the top of the rad at either end to do it. Anything I have looked up always refers to this valve.
There are two white caps on the pipes that connect to the rad at the bottom - but I dont want to risk undoing either of them in case water pours out everywhere.
Also a more basic question - do I have to turn off the heating or stop the water flor from the tank when I do it?
thanks
Paddy
I am a novice radiator bleeder, and have a problem - we have a rad where the top is cold and bottom warm, so suspect just needs to be bled to drain out the trapped air - however there is not a valve on the top of the rad at either end to do it. Anything I have looked up always refers to this valve.
There are two white caps on the pipes that connect to the rad at the bottom - but I dont want to risk undoing either of them in case water pours out everywhere.
Also a more basic question - do I have to turn off the heating or stop the water flor from the tank when I do it?
thanks
Paddy