L
Legion2008
Guest
Hi,
I've a problem with my immersion system, I was trying to fix new taps in my ensuite yesterday so I tried stopping all the water in the house from the hot press, I closed all the stop cocks at the back of the Immersion (3 in total) and then the single one at the front of the immersion tank.
This didn't stop the flow of water, however leaving the tap running in the bath meant that the nothing reached the sink taps which allowed me to do what I needed to to and change the taps. Once this was completed I opened back up all the stop cocks.
Water flow is now fine in all taps, problem is that now I don't seem to have any water heating up, the immersion system doesn't seem to heat up anything, there doesn't seem to be a problem with the boiler as all the radiators are heating up fine. It's a Potterton Boiler system, the only thing is the light under the tap signal on the control board isn't lighting up.
Anyone got any ideas that might help?
I've a problem with my immersion system, I was trying to fix new taps in my ensuite yesterday so I tried stopping all the water in the house from the hot press, I closed all the stop cocks at the back of the Immersion (3 in total) and then the single one at the front of the immersion tank.
This didn't stop the flow of water, however leaving the tap running in the bath meant that the nothing reached the sink taps which allowed me to do what I needed to to and change the taps. Once this was completed I opened back up all the stop cocks.
Water flow is now fine in all taps, problem is that now I don't seem to have any water heating up, the immersion system doesn't seem to heat up anything, there doesn't seem to be a problem with the boiler as all the radiators are heating up fine. It's a Potterton Boiler system, the only thing is the light under the tap signal on the control board isn't lighting up.
Anyone got any ideas that might help?