Hi,
I had a new GFSH installed just under a year ago (new boiler, rads, new pipes - everything replaced). I've only started using the heating again with the weather getting a bit colder and I've noticed that one of the rads isn't heating at all. All the other rads are heating fine but there is no heat in the pipes at either end on this particular rad even though the thermostat is turned up to 5.
I also had 2 small leaks repaired two months ago (pipes screwed into when putting boards back down, not by me!). The pressure gauge in the boiler is also reading 0.5 which looks to be very low.
Would anyone know if the problem might have been caused by the repair of the leaks or if the pressure is more likely to be the problem? (Would an annual service sort this out?)
Any ideas let me know. Thanks
I had a new GFSH installed just under a year ago (new boiler, rads, new pipes - everything replaced). I've only started using the heating again with the weather getting a bit colder and I've noticed that one of the rads isn't heating at all. All the other rads are heating fine but there is no heat in the pipes at either end on this particular rad even though the thermostat is turned up to 5.
I also had 2 small leaks repaired two months ago (pipes screwed into when putting boards back down, not by me!). The pressure gauge in the boiler is also reading 0.5 which looks to be very low.
Would anyone know if the problem might have been caused by the repair of the leaks or if the pressure is more likely to be the problem? (Would an annual service sort this out?)
Any ideas let me know. Thanks